Avaya S8730, Руководство по эксплуатации, Страница: 36 / 64

Port board connections
The graphic illustrates two E1–QSIG or T1–QSIG connections from MAS port boards to the
corporate telephone switching system. DSE and analog boards connect at the same location
on the back of the server.
1 Port board connection to corporate switch
2 Port board connection to corporate switch
Configuring and testing the port board
After the port board hardware installation is complete, you must configure and test the new
Dialogic board.
Note:
The following procedures apply only to an MAS that was already in service. If you installed
port boards in a new MAS, you must configure the MAS using the procedures described in
Avaya Modular Messaging Installation and Upgrades .
1. After the server boots, log on to the server using any valid Modular Messaging
account that has local administration privileges.
2. Use the Dialogic Configuration Manager to configure the new port board.
For detailed procedures, see the port board appendix of Avaya Modular Messaging
Installation and Upgrades .
3. Use the Dialogic Configuration Manager to verify the settings for all Dialogic port
boards as you previously recorded them.
4. If the switch administrator previously busied out the MAS ports on the switch, the
administrator must now bring the MAS ports back into service.
5. Test the Dialogic port board using the Dialogic Line Test application.
Adding and replacing an MAS port board
36 Maintaining the Avaya S8730 Server for Modular Messaging June 2009