Avaya S8730, Руководство по эксплуатации, Страница: 30 / 64

1. Turn the SW100 rotary switch located on the top of the board to set the board ID
according to the number of the slot in which the board is installed.
PCI slot number Board ID number
3 0
4 1
5 2
2. Set the SW1 slide switch located on top of the board to the OFF-hook position by
moving the switch toward the bracket of the board.
This switch position sets the hook-switch state so callers hear a busy signal when
the board is not initialized.
3. Move the P3 jumper on the top of the board on to pins 1–2 to disable power
budgeting.
Setting the D/41JCT-LS–EW board
Prerequisites
Determine in which slot in the PCI cage you will be installing the board. Slots in the PCI cage are
number 3 (bottom slot), 4 (middle slot) and 5 (top slot). If a system has one board, install it in
slot 3 (bottom). If it has two boards install them in slots 3 (bottom) and 4 (middle). If it has three
boards install them in slots 3 (bottom), 4 (middle) and 5 (top).
For the D/41JCT-LS-EW board, set the board ID, the hook-switch state and Computer
Telephony (CT) bus termination. CT bus termination is set by adjusting the JP2 jumper on the
side of the board. Set bus termination based on the following conditions:
Number of boards JP2 jumper CT bus termination
1 OFF Do not terminate bus.
2 Board 1: ON pins 1 and 2
Board 2: ON pins 1 and 2
Terminate bus on both
boards
3 Board 1: ON pins 1 and 2
Board 2: ON pins 1 and 2
Board 3: ON pins 1 and 2
Terminate bus on all
boards
Adding and replacing an MAS port board
30 Maintaining the Avaya S8730 Server for Modular Messaging June 2009