Avaya S8400, Установка и настройка, Страница: 39 / 80

Enabling the SIPI
Installing and Configuring the Avaya S8400 Media Server February 2007
39
Enabling the SIPI
1. Type
change system-parameters ipserver-interface
and press Enter .
2. On the IP Server Interface System Parameters screen, verify that the primary control
subnetwork address is correct.
The control subnetwork addresses typically match the most significant three octets of the
IP addresses of the server for the media gateway. The most significant three octets are the
first three groups of digits in the IP address. Select the
configure server
command on
the Maintenance Web Interface to see the IP address of the server.
An asterisk ( * ) to the right of the Control Subnet Address field means that
Communication Manager does not have the subnetwork information and the subnetwork
address displayed is incorrect.
3. If the information in the Control Subnet Address field is incorrect, use the Maintenance
Web Interface to change the media server configuration to match the Server IP address in
configure server
. Under Server Configuration and Upgrades, click Configure Server
to change the media server configuration. Then return to this procedure.
4. Set the Switch Identifier field to the switch ID letter. Acceptable switch ID letters are A
through J. A is the default setting.
5. Set the IPSI Control of Port Networks field to enabled .
6. Press Enter to save the changes.
Adding the SIPI to the system
1. Use the IP Server Interface Administration - Port Network SAT screen to add a SIPI. Type
add ipserver-interface PNnumber
and press Enter .