Avaya P460, Справочное руководство

Страница: 97 / 224

Chapter 2 Avaya P460 CLI Commands
Avaya P460 Reference Guide 87
set port disable
User level: read-write, admin.
Use the
set port disable
command to disable a port or range of ports.
The syntax for this command is:
set port disable <module>/<port>
Example:
set port duplex
User level: read-write, admin.
Use the
set port duplex
command to configure the duplex type of an Ethernet
or Fast Ethernet port or range of ports.You can configure Ethernet and Fast Ethernet
interfaces to either full duplex or half duplex.
The duplex status of a port in auto-negotiation mode is determined by auto-
negotiation. An error message is generated if you attempt to set the transmission
type of auto negotiation Fast Ethernet ports to half- or full-duplex mode.
The syntax for this command is:
set port duplex <module>/<port> {full|half}
module Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
P460-1# set port disable 4/1
Port 4/1 disabled.
module Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.