Avaya P460, Справочное руководство

Страница: 104 / 224

Chapter 2 Avaya P460 CLI Commands
94 Avaya P460 Reference Guide
The syntax for this command is:
set port negotiation <module>/<port> {enable|disable}
Example:
To disable autonegotiation on port 1, module 4:
set port redundancy
User level: read-write, admin.
Use the
set port redundancy
command to globally enables or disable the
redundancy pairs you have defined. Using this command will not delete existing
redundancy entries.
L
You must disable Spanning Tree before you can enable redundancy.
The syntax for this command is:
set port redundancy {enable|disable}
Example:
set port redundancy on/off
User level: read-write, admin.
Use the set port redundancy command to defines or remove redundancy pairs. The
link can be any port that does not belong to a LAG, or a LAG interface. Ensure that
module Number of the module (3-6). If you do not specify a number,
the ports on all the modules are shown.
port Number of the port on the module. If you do not specify a
number, all the ports on the module are shown.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
enable Enable port negotiation protocol
disable Disable port negotiation protocol
P460-1# set port negotiation 4/1 disable
Link negotiation protocol disabled on port 4/1.
P460-1# set port redundancy enable
All redundancy schemes are now enabled