Avaya Media Gateway G350, Руководство по установке

Страница: 29 / 60

Installing the Avaya G350 Media Gateway
Step 3: Attach ground conductors
Installation of the G350 Media Gateway 29
December 2003
Approved grounds
An approved ground is the closest acceptable medium for grounding the building entrance protector,
entrance cable shield, or a single-point ground of electronic telephony equipment. If more than one type
of approved ground is available on the premises, the grounds must be bonded together as required in
Section 250-81 of the NEC for the US or per the local electrical code regulations in the country of
installation.
•
Grounded Building Steel: The metal frame of the building where it is effectively grounded by one
of the following grounds: acceptable metallic water pipe, concrete encased ground, or a ground
ring.
•
Acceptable Water Pipe: A metal underground water pipe, at least 1/2-in. (1.3 cm) in diameter, in
direct contact with the earth for at least 10 ft. (3m). The pipe must be electrically continuous (or
made electrically continuous by bonding around insulated joints, plastic pipe, or plastic water
meters) to the point where the protector ground wire connects. A metallic underground water pipe
must be supplemented by the metal frame of the building, a concrete-encased ground, or a ground
ring. If these grounds are not available, the water pipe ground can be supplemented by one of the
following types of grounds:
— Other local metal underground systems or structures - Local underground structures such
as tanks and piping systems.
— Rod and pipe electrodes - A 5/8-in. (1.6 cm) solid rod or 3/4-in. (2 cm) conduit or pipe
electrode driven to a minimum depth of 8 ft. (2.4 m).
— Plate electrodes - Must have a minimum of 2 sq. ft. (0.185 sq. m) of metallic surface
exposed to the exterior soil.
•
Concrete Encased Ground: An electrode encased by at least 2 in. (5.1 cm) of concrete and located
within and near the bottom of a concrete foundation or footing in direct contact with the earth.
The electrode must be at least 20 ft. (6.1 m) of one or more steel reinforcing bars or rods, 1/2-in.
(1.3 cm) in diameter, or at least 20 ft. (6.1 m) of bare solid copper, 4 AWG (26 mm
2 ) wire.
•
Ground Ring: A buried ground that encircles a building or structure at a depth of at least 2.5 ft
(0.76 m) below the earth’s surface. The ground ring must be at least 20 ft. (6.1 m) of 2 AWG
(35 mm
2
), bare copper wire.
•
Approved Floor Grounds: Floor grounds are those grounds on each floor of a high-rise building
that are suitable for connection to the ground terminal in the riser closet and to the cabinet single-
point ground terminal. Approved floor grounds may include the following:
— Building steel
— The grounding conductor for the secondary side of the power transformer feeding the
floor
— Metallic water pipes.
— Power-feed metallic conduit supplying panel boards on the floor.
— A grounding point specifically provided in the building for that purpose.
!
WARNING:
If the approved ground or approved floor ground can only be accessed inside a dedicated power
equipment room, then connections to this ground must be made by a licensed electrician.