Page 20 - Installation of Integral Modules
Installing a New System
Installation of Integral Modules
An Avaya IP Office - Small Office Edition can be fitted with a WAN module, a quad BRI
module or a PRI/T1 module. In addition, either or both the optional PCMCIA cards
(Memory and/or Wireless LAN) can be fitted.
Procedure:
1. To add either a wireless LAN or additional Memory card you do not need to de-
assemble a module, simply insert the card (item ) into either of the PCMCIA slots in
the rear panel . These slots are universal, hence the location does not matter. Only one
Memory or wireless LAN card can be fitted.
2. To add a WAN or BRI or PRI/T1 module:
Remove the top cover (item ) from the base cover by removing the four retaining
screws (two either side - items ) and proceed as follows.
3. Remove the rear panel (item ).
Only discard if a WAN module is being fitted (see step 4 below).
On the rear panel, press out all of the knock-out panels (item
\
) for a Quad BRI or just
the middle one for a PRI/T1.
- Plug the trunk board (item ) onto it's sockets and stand-off hex. pillars.
- Ensure that the trunk module sockets slot into the hole in the rear panel
(item
\
). Secure the trunk board in position and with the two snap-in spacers.
- Mount the existing rear panels if a WAN module is not being fitted.
If a WAN module is being fitted, see the next step.
4. To add a WAN module:
- Remove and discard the rear panel (item ).
- Fit the new rear panel (supplied with the WAN module and has a slot for WAN port
27-way D-type, items ).
- On the rear panel, press out all of the knock-out panels (item
\
)
- Mount WAN module (item ) in position and secure with the two snap-in spacers.
Caution:
While installing modules, ensure that you wear aground wrist strap that is
connected to a suitable grounding point.
Page 20 - Installing a New System
IP Office - Small Office Edition Installation Manual
Installation of Integral Modules
40DHB0002UKED – Issue 2 (29th July 2004