Page 24 - Configuration
Configuration
IPSec Configuration
The IP Security form is used to configure an IPSec security policy between two IPSec
peers. Three tabs are available on the IPSec form (Main, IKE and IPSec). The Main tab
is used to set the IP addressing conditions and Local/Remote gateway IP addresses
while the IKE and IPSec Policies tabs are used to configure specific IPSec parameters.
The general method of IPSec configuration is shown below:
1. Configure and test IP connectivity between the two peers.
2. Configure an IPSec form and set the IP addressing conditions to trigger a Security
Association (SA).
The IP Security Menu
Access to this menu is:
1. With the Manager application open, click on
Tunnel
.
2. Click the
IPSec
radio button and then click
OK
.
3. The following menu is displayed:
Figure 9. The IP Security Menu
Caution:
Although the IPSec Menu is displayed and can be completed, a valid
IPSec Tunneling licence is required for the feature to be activated.
Indication of the absence of a License is given in the SysMonitor
application when an attempt is made to activate the configuration; an
example of this message is shown below.
29967mS IPSecEvent: IPSec Not Licensed - VPN security is not
available
32005mS PPP LCP Rx: v=wan_link
Page 24 - Configuration
IP Office (R3.0)
IPSec Configuration
40DHB0002UKER Issue 3 (4th February 2005)
