Page 40 - System Diagnostics and Testing
Page 40
Compact DECT - Installation Manual
Base Stations Signal Checks
38DHB0002UKFH – Issue 5 (27th October 2003)
System Diagnostics and Testing
Base Stations Signal Checks
The 20DT handsets can be used to check the signal strength and quality
being received.
1. With the handset on-hook, dial
*99981*
and press
ENTER
.
2. The handset display should be similar to that shown below.
RPN: 01 03
Q52: 52
RSSI: 64
–
RPN
is the Base Station number.
–
Q52
refers to the speech quality (error rate) of the signal received
from a Base Station. Only the speech quality of the first available
base station is displayed. A value of 52 or greater is acceptable.
–
RSSI
refers to the signal strength from each base station. A value
of 64 or greater is acceptable.
3. Put the handset off-hook, this gives more accurate and realistic survey
figures.
4. To clear the display press
<
until you hear a short bleep.
Handset Software Version
The handset can provide details of its internal software version. It is unlikely
that you will need these details except if requested by the handset supplier.
1. With the handset on-hook, dial
*99982*
and press
ENTER
.
2. The handset display should be similar to that shown below.
1329 8100
SW PCS: 4
3. To clear the display press
MENU
twice.
Battery Condition
The handset can display its battery charge. This appears as a set of eight
blocks across the display. Solid blocks indicate charge and empty blocks
indicate discharged. If three blocks or less appear then the handset should
be recharged.
The battery state can be checked via the
MENU
key options.