Page 24 - Using Windows CCFP Administration
Page 24
Compact DECT - Installation Manual
Starting CCFP Admin - Direct Connection
38DHB0002UKFH – Issue 5 (27th October 2003)
Starting CCFP Admin - Direct Connection
Starting CCFP Administration
1. Ensure that the DECT system is on and that the serial cable is connected
to it (
see page 44
).
2. Locate and click on the CCFP Administration icon.
– Located
in
Start | Programs | CCFP Administration.
If you receive a message stating that communication between the CCFP
and the PC failed, then check the cabling and/or change the COM port
settings (see pages 23 and 24 respectively).
3. A start-up display appears. The base of the display shows the current
communications settings that will be used to connect with the DECT
system.
4. The moving bar across the display allows approximately 10 seconds to
change the communication settings (see
Changing the Communications
Configuration
on page 24) before it attempts to make the connection with
the DECT system.
5. A configuration display momentarily appears. It will state:
-
500 system detected
Ensure that the correct system configuration has been selected.
6. After a caution message, the main
CCFP Administration
screen
appears.
– If the connection is okay, the screen shows handset
Registration
page. The progress indicator at the top-right of the screen shows the
progress in copying down the DECT system's settings.
– If the connection is not okay, the screen shows the
Status
page with
a sequence of
---TIMEOUT---
messages. Use
File
|
Exit
to close the
program and then check the serial port, serial cable and DECT
system.
– If
Error 5
appears, then another device is using the COM port.
Changing the Communications Configuration
1. Whilst the start-up display is shown, clicking on
Change
communications configuration
pauses the startup and display the
Communications Setup
menu.
2. Set
the
Com.
port to match the serial port of your PC connected to your
DECT system (for direct serial cable connection) or modem (for remote
modem connection to the DECT system).
3. Set
the
Connection:
to the type of connection required, i.e.
Direct
.
4. If you wish to keep a log on communication between the CCFP and the
PC, tick the
Enable Log
box.
5. Either accept the default bit rate (19200) or change it to 9600.
6. Click
on
OK
to return to the CCFP Administration startup display.
7. If the communication between the DECT and the PC fails, check the
cable connection (see 23).
