Avaya BSGX4e, Руководство по установке

Страница: 24 / 56

BSGX4e Business Gateway Installation Guide 24
Release 01.01 NN47928-303
ICAD> show interface ip eth0
The unit responds with a display similar to the following:
“eth0” info:
Interface eth0
Flags (A843) < UP BROADCAST RUNNING SIMPLEX
LINKUP MULTICAST >
IP Address/Mask 192.168.15.33/255.255.255.0
MTU 1500
DHCP on
Lease obtained THU JUN 22 11:04:16:2006
Lease expires THU JUN 22 13:04:16:2006
MAC Address 00:11:22:33:66:77
Speed FULL100
Configured Speed AUTONEG
2. Look at the IP Address/Mask line. It shows the address and mask assigned to
the eth0 (WAN) interface. If the address is correct, skip to the procedure
Default Gateway Address (page 25) .
3. If the address is incorrect or unspecified (0.0.0.0), look at the DHCP line. It
shows whether the DHCP client is enabled (on) or disabled (off). If the DHCP
client is on, but the IP address is 0.0.0.0, the DHCP service is not working for
the unit.
4. To manually enter the correct IP address and subnet mask, the DHCP client
must be disabled (off). To disable the DHCP client, enter this command:
ICAD> config interface ip eth0 dhcp no
5. Then, to manually enter the eth0 IP address and subnet mask, enter:
ICAD> config interface ip eth0 address/mask
Specify the address and mask with dotted-decimal or Classless Inter Domain
Routing (CIDR) notation (for example, 192.168.15.33/255.255.255.0 or
192.168.15.33/24).
6. To verify the entry of the address and mask, enter the show command again:
*ICAD*> show interface ip eth0
Assuming that the DHCP client is off, the unit responds with a display similar
to the following:
“eth0” info:
Interface eth0
Flags (A843) < UP BROADCAST RUNNING SIMPLEX
LINKUP MULTICAST >
IP Address/Mask 172.29.250.50/255.255.0.0
MTU 1500
DHCP off
Lease obtained N/A