Avaya BSGX4e, Руководство по установке

Страница: 20 / 56

BSGX4e Business Gateway Installation Guide 20
Release 01.01 NN47928-303
Connecting an optional analog device
These steps connect the BSGX4e FXS port to an analog telephone or fax device. (This
procedure is optional; the BSGX4e can control a LAN without an analog device.)
CAUTION: Do not connect the PHONE port to the CO Public Switched Telephone
Network (PSTN) phone line.
1. Connect one of the connectors of an RJ11 to RJ11 cable to the port labeled
PHONE on the back panel of the BSGX4e. See Figure 4 .
2. Connect the RJ11 connector on the other end of the cable to the analog
device.
3. Put the analog device into an off-hook state (for example, lift the handset of
an analog phone). While the analog device is off-hook, check that the LED
labeled PHONE on the front panel of the BSGX4e is lit green. If it is not, ensure
that the device is off-hook and that both ends of the cable are securely
connected.
4. Return the analog device to its on-hook state. The PHONE LED is no longer lit.
Connecting the lifeline
These steps connect the BSGX4e FXO port to the CO line (PSTN) to act as a
telephone lifeline when VoIP phone service is not available. (VoIP service is not
available when the WAN connection or the required servers are not available.)
1. Connect one of the connectors of an RJ11 to RJ11 cable to the port labeled
LINE on the back panel of the BSGX4e. See Figure 4 on
page 18
.
2. Connect the RJ11 connector on the other end of the cable to the CO (PSTN)
phone line.
3. The LED labeled LINE on the front panel of the BSGX4e is not lit unless the CO
(PSTN) phone line is off-hook. The BSGX4e uses this line only when VoIP
service is unavailable, and the BSGX4e switches to Local Call Routing mode.
Verification of the LINE connection requires a debug command, and so it can only
be performed later in the install procedure, after you log on to the BSGX4e
(described in
Logging on to the BSGX4e (page 21) ).
To verify the LINE connection, enter these commands:
ICAD> debug enable
ICAD> dshow interface fxo
If the LINE (FXO) is connected, but idle, the unit responds:
FXO Port Status:
Port Status
------------------------------------------
0-0 IDLE