Avaya AA1419043-E6, Руководство по установке, Страница: 51 / 72

Removing an SFP+
Remove an SFP+ to replace it or to commission it elsewhere.
About this task
Warning:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables connect to a
light source.
Electrostatic alert:
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Procedure
1. Disconnect the network fiber optic cable from the SFP+ connector.
2. Pull the swing-down latch handle and use it to extract the module.
3. Slide the SFP+ out of the module SFP+ slot.
If the SFP+ does not slide easily from the module slot, use a gentle side-to-side
rocking motion while firmly pulling the SFP+ from the slot.
4. Affix dust covers over the fiber optic bore and connector.
5. Store the SFP+ in a safe place until needed.
Important:
If you discard the SFP+, dispose of it according to all national laws and
regulations.
SFP+ specifications
This section provides technical specifications for the supported 10 gigabit SFP+ models. Use
these specifications to aid in network design.
The specifications in this section are a subset of the IEEE 802.3ae, 802.3aq, and 802.3ak
specifications. For more information, see these standards documents. All Avaya SFP+
transceivers meet or exceed these standards.
SFP+ specifications
Installation — SFP Hardware Components December 2012 51