Avaya AA1419043-E6, Руководство по установке, Страница: 49 / 72

Installing an SFP+
Install an SFP+ to provide a 10 Gb Ethernet interface between the device and other network
devices.
Before you begin
Important:
Do not install an SFP+ transceiver in an SFP slot. The two transceivers look the same but
function differently. Ensure the slot is an SFP+ slot.
• Verify that the SFP+ is the correct model for your network configuration.
• Before you install the optical connector, ensure it is clean.
Warning:
Risk of eye injury by laser
Fiber optic equipment can emit laser or infrared light that can injure your eyes. Never look
into an optical fiber or connector port. Always assume that fiber optic cables connect to a
light source.
Electrostatic alert:
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Caution:
Risk of equipment damage
Only trained personnel can install this product.
Caution:
Risk of equipment damage
SFP+ transceivers are keyed to prevent incorrect insertion. If the SFP+ resists pressure, do
not force it; turn it over, and reinsert it.
About this task
Installing an SFP+ takes approximately three minutes.
Procedure
1. Remove the SFP+ from its protective packaging.
2. Grasp the SFP+ between your thumb and forefinger.
3. As shown in the following figure, insert the device into the slot on the module.
SFP+ transceivers
Installation — SFP Hardware Components December 2012 49