Avaya 3920, Руководство по установке

Страница: 45 / 60

4 Installing a Repeater
Installing a Repeater in a Daisy-Chain Configuration 45
Planning and Installation Guide
5
Start the repeater configuration software.
6
From the COM port box at the top of the repeater configuration software
window, select the COM port to which repeater N1 is connected.
7
In the RFPI box, enter the RFPI for repeater N. You recorded this
information in Step 9 in the previous section.
8
Click the mouse in the PARK box. The software will automatically display
the PARK information and RPN information for repeater N.
9
Click the Ignore HOP control check box.
10
If you do not want the handset to beep when it is connected to the repeater,
clear the
Monitor beep check box.
11
Click the Save button.
12
Unplug the
AC adapter from the wall outlet
.
13
Unplug the splitter from the power connector on repeater N.
14
Unplug the AC adapter from the splitter.
When finished, go to “Procedure 5: Register Repeater N1 to the Base” on
page 45 .
Procedure 5: Register Repeater N1 to the Base
After you have configured repeater N1, you must register it to the base unit.
Perform the following steps:
1
Set the base of the Avaya 3920 Wireless Telephone into registration mode
by pressing and holding the registration button on the base for 3 seconds.
The indicator on the base flashes.
2
Plug the AC adapter cord into the AC adapter input jack on the repeater.
3
Plug the AC adapter into a standard 120VAC wall outlet near the base unit.
The repeater must be near the base unit. The LED on the repeater flashes
briefly and then remains on. The repeater is now registered to this base and
is ready to use.
If the LED continues to flash, try registering the repeater again.