Avaya 3920, Руководство по установке

Страница: 43 / 60

4 Installing a Repeater
Installing a Repeater in a Daisy-Chain Configuration 43
Planning and Installation Guide
Procedure 3: Configure Repeater N
In this section, you will connect repeater N to the PC that is running the repeater
configuration software and configure repeater N.
Perform the following steps:
1
Connect the splitter to the power connector on repeater N. See Figure 21 .
2
Plug the AC adapter into a port on the splitter.
3
Plug the customized RJ-11 to serial DB9 PC connection cable into the other
port on the splitter.
4
Plug the
AC adapter cord into a standard 120VAC wall outlet
.
5
Connect the other end of the customized RJ-11 to serial DB9 PC
connection cable to the properly configured COM port on your PC.
6
Start the repeater configuration software.
7
From the COM port box at the top of the repeater configuration software
window, select the COM port to which repeater N is connected.
8
Click the Load button. The software loads the configuration information
from repeater N and displays it in the window.
9
Record the information displayed in the Repeater RFPI box at the bottom of
the window. (You will use this information in the next section.)
10
If you do not want the handset to beep when it is connected to the repeater,
clear the
Monitor beep check box, and click the Save button.
11
Click the Quit button to exit the application.
12
Unplug the
AC adapter from the wall outlet
.
13
Unplug the splitter from the power connector on repeater N.
14
Unplug the AC adapter from the splitter.
When finished, go to “Procedure 4: Configure Repeater N1” on page 44 .