AVANT e6 2018, Руководство оператора

Страница: 53 / 108

Avant e6
53
.
Stopping the loader (Safe stopping
procedure)
WARNING
Safe stopping procedure
Stopping the loader and its
attachment to a safe state
1.
Lower the boom completely
down.
2.
Stop any attachment (move
auxiliary hydraulics control
lever to neutral position, see
page 39), set hand throttle to
rear position. Place the
attachment firmly on the
ground.
3.
Engage the parking brake.
4.
Stop the motors by turning
the ignition key to the OFF
position (turn to the left).
5.
Release auxiliary hydraulics
pressure (see page 68).
Move the boom control lever
and the control lever of the
telescopic boom towards all
of their extreme positions to
release residual pressure
from the hydraulic circuits of
the boom.
6.
Prevent unauthorised use of
the loader. Take the ignition
key with you. If parking on a
slope is necessary, use
additional wheel chocks to
prevent the loader from
moving.
.
.
Stop if you notice any of the following:
Stop the loader to a safe state as
soon as possible if you observe
any of the following symptoms.
Find out the cause before
restarting.

Battery charge level is below 10 %. Drive to
a charging location and avoid heavy load

Electric motor rpm increases and/or
decreases suddenly by itself, even if you
don't move the throttle lever, or press the
pedals

You notice sudden increase in vibration or
noise levels

You notice a leak
.
.
Battery disconnect switch
The loader is equipped with two electrically
controlled battery disconnect switches (main
switches) - There is no separate, manually usable
main switch. The automatic battery disconnect cuts
the current between battery and the rest of the
electric system whenever ignition key is switched to
position OFF.
To switch on the electric systems of the loader, turn
the ignition key to position
P or ON and wait for a few
seconds. The battery main switch is activated in
position
P , and main switch for inverters in position
ON .