La PETITE-R rev.6 04/2013
· -
INSTALLATION AND SERVICE MANUAL AVALON
La Petite-R
26
www.cafection.com
(800) 561-6162
Initial Setup
6.4.2 Adjusting the Tank Overflow Float
It is important to verify that the float is positioned appropriately in the
overflow cup since it can move around in transportation. If this float is
not in place the switch will not be activated and the unit will automatically
shut down sensing an overflow situation.
It is important to verify that the Overflow cup is in place with the highest
side in the front and secured with the green tape. If you need to remove
this cup, please make sure that you replace it with the highest section
facing the front and the overflow tube in the cup. Fasten in place with
tape. This will ensure that the float will “float” and will activate the
overflow switch if there is a problem.
6.5
Water Line Connection
This equipment must be installed in compliance with applicable Federal,
State and/or Municipal plumbing codes having jurisdiction.
Make sure that the equipment is unplugged before proceeding with the water supply installation.
Also verify that the incoming water pressure is greater than 20 psi and no more than 80 psi.
1.
Prior to installing the unit, flush out the water line by running approximately 1 gal. of water into a
pail. This will ensure no sediment from a new installation can get in the unit;
2.
The incoming water supply should have a shut-off valve connected in-line. Water supply should
be a plastic 1/4” or 3/8” O.D. dedicated line branched off a larger supply line;
3.
Make sure your water source is turned off. Secure the inlet fitting firmly onto the inlet valve. Do
not overtighten;
4.
Make sure the equipment is unplugged. Connect the water line to the quick connect inlet fitting;
5.
Turn the water valve on, sending water to the brewer. If there are any leaks, tighten connections
to stop leakage.
This procedure does not take into consideration the installation of a water filtration
system. Please refer to the water filter manufacturer installation instructions and
incorporate them into the above.
