AUTOTERM PLANAR - 8DM - 12, Руководство по эксплуатации

Страница: 47 / 50

PLANAR-8DM-12/24 ENG
8.5 Installation of heater electric circuit
Heater wire harnesses shall be installed in compliance with the heater wiring system as
shown in figure 4.1. When installing, do not allow the wire harnesses to become
overheated, deformed or dislodged during vehicle use. Attach the harnesses to the vehicle
fittings using plastic clamps.
Attention! Installation should be performed with the fuse disconnected.
9 Post-installation testing
9.1 When installing, ensure that:
- the fuel supply system is leak-proof
- the electric contacts of the harnesses and heater elements are securely installed
9.2 Install fuse 25 А .
9.3 Fill the fuel pipe system with fuel with the help of fuel pumping device (fuel
pumping device can be ordered at manufacturer).
9.4 Check that the heater is working :
- in ventilating mode,
- in heating mode.
The process of activation begins with purging of the combustion chamber. After
purging the process of combustion begins and the heater goes on working in operation
mode.
9.5 Deactivate the heater. While switching off the heater the fuel stops entering and the
process of ventilation of the combustion chamber and heat exchanger starts.
9.6 Activate the heater while the vehicle engine is running and ensure that the heater is
operational.
ATTENTION!
1. When performing initial ignition following installation, the fuel supply line
should be filled with fuel using a fuel pumping device until the fuel level reaches the
inlet plug of the heater. If there is no pumping device, restart the heater as many times
as necessary to fill the fuel supply line.
2. Remember that each time the heater fails to start at the first attempt, the
heater will be restarted automatically by the control unit.
3. The cabin remote sensor must be disconnected, if you need to start the heater
when the temperature of air more than 30
°
C
10 Recommendations
10.1 To ensure consistent performance, the heater should be switched on for up to 5-10
minutes each month throughout the year (warm seasons included). This will prevent the
moving parts of the fuel supply pump from sticking. Failure to comply with this advice
may cause malfunctions in heater operation.
10.2 Reliable performance depends on the type of fuel used depending on the
atmospheric temperature.
22