User Guide
P. 19
Diagnostics – Parking Light Flash Table
Flashes
Description
1
•
Doors locked, starter kill armed.
•
Run time has expired.
•
TRUNK
button pressed.
•
Start signal received by the module.
•
Cold weather mode cancelled.
2
•
Doors unlocked, starter kill disarmed.
•
Remote start attempt cancelled by remote.
•
Exiting ignition valet.
•
Exiting remote valet.
•
Power-up reset.
•
Board set from manual to automatic; power
ON.
•
Power ON to OFF (
automatic transmission
).
2 slow flashes then
8 quick flashes
•
Reset from Manual to Automatic
3
•
Entering cold weather mode.
•
Extended run time.
•
Entering or exiting Ready Mode
•
Entering ignition valet.
•
Entering remote valet.
•
Disabling LED
4
•
+12 V detected on the brake input wire either while cranking or during run time.
•
Entering multi-speed tach programming.
•
Board set from automatic to manual; power ON.
•
Power ON to OFF (
manual transmission
).
5 Fast
•
Tach signal programmed.
6
•
A remote start was attempted while a tach-before-crank signal was detected before cranking.
8
•
Unit reset
10
•
A ground (-) signal was detected on the hood pin input wire.
When pressing
START/STOP
15 quick flashes…
•
The parking brake is connected to ground (
automatic transmission
).
1 – pause – 2
•
There was a remote start attempt while the vehicle was in valet mode.
•
Failed start: vehicle’s low battery voltage.
…followed by 1 flash
Exiting cold weather mode
ON SOLID for 3
seconds….
…followed by 3 flashes
Entering cold weather mode
ON continuously
•
Idle mode:
Idle mode is engaged
•
Run time:
The vehicle has been remote started and is in run time.
ON 2 seconds
•
The hood has been opened and a ground (-) signal has been detected on the hood pin input
wire.
ON 4 seconds
•
Locking or unlocking a door (with Door pulses configured to 4 sec.)
ON 20 seconds
•
The hood pin has been flashed and you are now in the programming centre.
Continuous flashes
25 seconds
•
Panic mode is activated.
Continuous flashes
60 seconds
•
OEM alarm triggered (Honk)
