ColorMFA Manual, firmware v2.9.4_b31
20
Backlight
Adjust the brightness (backlight) of the screen. You can choose manual or automatic mode
(automatic mode works properly only if there is an ambient light sensor in the instrument panel.
Instrument panels that had a factory screen named Full FIS or MFA have this sensor. Lowline no
factory screen clusters do not have this sensor). In manual mode, you can set the brightness as
you like.
The correlation between the input brightness value (according to the standard dash light
control module in the car) and the output value (screen brightness) can be adjusted by selecting
the
«Calibration»
item. The calibration screen shows, in percent, the minimum and maximum
value of the input brightness value (In) and the corresponding minimum and maximum value of
the brightness of the screen backlight (Out). This setting only works when automatic brightness
control mode is selected.
Car image
Choose a picture of the car to display the status of doors / hood /
trunk. In firmware intended for a specific car model, the choice of picture
may not be available if such a model was produced in a single body vari-
ant.
