Automaxx 1500 Watts Wind Turbine, Руководство пользователя

Страница: 42 / 48

40
Suggested Battery Charger Set points:
The battery manufacturer should provide you with specific instructions on the
following maintenance and charging regulation set point limits for the specific
batteries. The following information can be used when the manufacturer's
information is not available. Note: Higher settings can be used with non-
sealed batteries, but water consumption will be greater and excessive
temperatures when charging may occur.
Sealed Lead Acid – AGM GEL 24V / 48V
ABSORB voltage set point 28.6V / 57.2V
FLOAT voltage set point 27.2V / 54.4V
Non-Sealed Lead Acid 24V / 48V
ABSORB voltage set point 29.6V / 59.2V
FLOAT voltage set point 27.2V / 54.4V
Multi –Stage Battery Charging
The MPPT charge controller is a sophisticated multi-stage battery charger
that uses several regulation stages to allow fast recharging of the battery
system while ensuring a long battery life. This process can be used with both
sealed and non-sealed batteries. The MPPT will automatically set the charging
regulation voltage set points (absorb & float) for the selected nominal battery
voltage, however, always follow the battery manufacturer’s recommended
charging regulation voltages. The MPPT charging regulation stages
correspond to the chart below.
Bulk
This stage provides the maximum power to the battery -- voltage increases
while charging.
A bulk charge is automatically initiated when the battery voltage is below the
absorb and float voltage set points. The bulk charge will continue until the
absorb voltage set point is achieved.