Automatismos Pujol SC 600 II Series, Руководство пользователя

Страница: 39 / 44

38
SC 600 II
7. Set up and operation
a. Adjust of the Potentiometers (see Fig.8)
VR1: Working time adjustment.
Clockwise rotation to increase, counterclockwise rotation to reduce. The total time can be set to 10 seconds as minimum and 90
seconds as maximum.
VR2: Speed of soft stop adjustment.
Clockwise rotation to increase, counterclockwise rotation to reduce. Rotate to minimum to cancel the soft stop.
VR3: Soft stop width adjustment. Clockwise rotation to increase, counter-clockwise rotation to reduce.
VR4: Motor output force adjustment to keep safety. Clockwise rotation to increase, counter-clockwise rotation to reduce.
Warning: Motor force can not be set too large, just drive the door is ok.
Remote control
The remote control works as impulse mode. With each press of the remote control button which has been programmed, the gate
will close, stop, open or stop cycle.

Adding extra remote controls (Learn): Remove the cover, press and hold the learn button ‘S1’ (Fig.8) more than 2
seconds, then the ‘LED of LEARN’ (Fig.8) will be on, then press the remote control button which you want to use, the ‘LED’
will turn on about 2 seconds and then turn off again. The learning process is finished. Up to 25 remote controls may be
used.

Erase remote controls: To erase all existing remote controls, press and hold learn button ‘S1’, the LED of ‘LEARN’ will turns
on, release the button until the LED turns off. This indicates that all the remote controls have been erased completely.

Verify open direction: If the gate does not move in the desired direction, then you will need to reverse the motor
operating direction, open the black plastic cover, you can do this by exchanging wires ‘MOT1’ and ‘MOT2’, ‘Open limit(13
of J5)’ and ‘Close limit(11 of J5)’.
8. Adjust the DIP switch
（
see Fig13 and table 1
）
1 2 3 4 1 2 3 4
1 2 3 4 1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
1 2 3 4
Fig. 13A Fig.13B Fig. 13C Fig. 13D
https://appceso.com