42
GDO-10V2L2 Toro
™
Owner Installation Instructions
Warning: Do not connect the batteries until
after Step 18.2
30 Watt Solar Kit Part Number 60142 is suitable
for GDO10-V2
Step 19.1 - Mount The Charger Board
Unplug the drive unit from mains power.
Disengage motor using manual release cord.
Remove the bottom cover by pressing in from sides
and sliding downward.
Remove the two screws and slide the top cover
upward to remove it.
Remove the transformer, EMC board and mains
power cable.
Remove the two screws from the battery bracket
then remove the batteries and harness
Fix the Charger Board Holder to where the
transformer was removed from. Fix the charger
onto the charger holder
(Fig. 65)
Feed the two wire cable through the opening, then
connect the red wire into solar + and black wire into
solar - connector on the control board.
Move the shunt from “STBY BATT” to “SOLAR” on
the control board in the power head.
Warning: Do not connect battery or solar panel
polarity incorrectly - this will result in serious
damage to components. During Step 2, the
opener will become active.
Step 19.2 - Connect The Solar Panel
Mount the solar panel as described in the
SmartSolar™ Instruction Manual.
Feed the Solar Panel’s cable through the black
grommet on the chassis.
Connect the
red wire
to the Charger Board’s
“
SOLAR+
” connector, and the
black wire
to the
“
–SOLAR
” connector.
Step 19.3 - Mount & Connect The Battery
Mount the Battery Box close to the opener.
Feed the 2-core 18 awg gauge cable (supplied)
through the Battery Box’s grommet.
Connect the
red wire
to the Battery Box’s “
+
”
terminal, and the
black wire
to the “
–
” terminal
(Fig. 68)
.
Feed the other end of the battery cable through the
drive unit’s black grommet.
Connect the
red wire
to the Charger Board’s
“
BAT+
” connector, and the
black wire
to the “
–
BAT
” connector
(Fig. 67)
.
Refi t the timing cover, main cover and light diffuser.
Step 19.4 - Re-Setup And Test The Opener
Setup travel limits and code transmitters as per the
GDO10-V2 instruction manual.
Press either the OPEN/CLOSE button, or use a
transmitter to operate the opener.
1.
2.
3.
4.
5.
6.
7.
8.
9.
1.
2.
3.
1.
2.
3.
4.
5.
6.
1.
2.
SmartSolar™ Installation
65
Fig
RR
E
D
T
O
C
O
N
T
R
O
L B
O
A
R
D
B
LA
C
K
T
O
C
O
N
T
R
O
L
B
O
A
R
D
B
la
ck
(F
ro
m
B
at
te
ry
)
R
e
d
(F
ro
m
B
at
te
ry
)
B
la
ck
(F
ro
m
S
o
la
r P
an
e
l)
R
e
d
(F
ro
m
So
la
r P
an
e
l)
67
Fig
Re
d W
ire
Black
Wire
68
Fig
66
Fig
