Installation Instructions
Axess
®
Pro 1505
9
6. Installation
6.1 Mounting The Drive Unit
a. Determine the centre of the door and mark this point on
the wall above (
Fig. 6.1
).
b. Raise the door to the open position.
c. Measure 50mm above the top of the door (at the doors
highest point) and mark this position (
Fig. 6.2
).
d. Mark the position of the wall bracket
8
holes on the
wall above the door (
Fig. 6.3
). Check the bottom of the
bracket is a minimum of 50mm above the top of the door
when in the open position.
e. Secure the wall bracket
8
in place with loxins or
appropriate fasteners (not supplied).
NOTE:
The supporting structure where the bracket is
mounted, must be capable of supporting 2kN push / pull
force.
f. Measure 4080mm (+ /- 150mm) across the ceiling from the
wall centre point (
Fig. 6.2
). Install perforated angle or similar
(not supplied).
g. Turnover the drive unit
1
and pull the ring located at
Y
to release the vent (
Fig. 6.4
).
h. Raise the opener into position using suitable equipment
for the height of the door.
NOTE:
The drive unit weighs over 25kg and therefore may
require 2 persons to mount into position.
i. Connect the rail
22
to the wall bracket
8
and mount the
opener to the perforated angle.
Fig 6.1
Track
Door
Fig 6.2
Fig 6.3
Fig 6.4
Perforated angle
8
50mm minimum
4080mm minimum (+ / - 150mm)
Y
THIS PRODUCT REQUIRES A TWO PERSON LIFT TO MOUNT ON MOST DOORS
- use proper lifting techniques and equipment to suit the site.
