INSTRUCTIONS CABRI-30P/35P
Page11
SWING GATE OPENER
11). “C” value is 139mm.
12). “D” can be measured from the gate easily.
13). “A” = “C” + “D”
14). The value of “B” can be calculated from the value of “A” and the leaves opening
angle. Ex. If “A”=160mm with the leaves opening angle of 100 degrees, then the
value of “B” is approximate 190mm.
**Please make sure “B” and “A” are similar or the same in value that the leaves
can be operated smoothly, also to reduce the burden of the motor.
2.3.2 Installation of The Gear Motors
1. Choose the correct dimensions of the motors and position to be installed.
2. Check if the mounting surface the brackets to be installed is smooth, vertical
and rigid.
3. Arrange the cable conduit for power supply cable of the motors.
4. In order to obtain the optimal supporting from the rear plate, please assemble two
post brackets and one rear metal plate according to Figure 16.
5. Loosen the two screws and remove the back cover of the motor as shown in
Figure 19.
6. Place the leaves in the closed position
7. Refer to the distance of “B” in Figure 15, place the rear plate in the correct position
on the mounting surface. Inspect if the distance is proper as shown in Figure 21 i.e.
the position the front plate of the motor to be installed.
8. Place two post brackets on the surface to be installed and mark the drilling points,
then drill minimum diameter of 8mm holes by four on the mounting surface to be
installed and fasten up the brackets with screws and washers.
9. Please make sure the front plate is completely installed horizontally.
