INSTRUCTIONS CABRI-30P/35P
Page14
SWING GATE OPENER
23.
Gear Motor Release
1) Turn the round plate on the release part to “OPEN” position. Figure 27.
2) Push out the release part to the end. Figure 28.
3) Use the release key to turn the pin anti-clockwise to the end. Figure 29.
Figure 27 Figure 28 Figure 29
2.3.3 Flashing Light
1) Decide the installation position of the flashing light. The flashing light has to be
installed near the gate and easy to be seen by users and passersby. The flashing
light can be installed horizontally or vertically.
Figure 2.3.3 (1).
2) Unscrew the four screws on the light base and separate the base with the bottom
as shown in
Figure 2.3.3 (2).
3) Connect the wires and penetrate the wires into the hole of the base.
Figure 2.3.3 (3).
4) Drill the holes in the wall and fix the bottom to the wall by three screws.
Figure 2.3.3 (4)
Figure 2.3.3(1) Figure 2.3.3(2) Figure 2.3.3(3) Figure 2.3.3(4)
5). Connect the two wires of the light to the PCB terminals and place the wires into the
conduit if necessary. See Figure 2.3.3 (5).
6). Tighten the four screws back on the light base. Figure 2.3.3 (6)
7). Replacing the bulb set. See Figure 2.3.3 (7)
