autogaz AC STAG-100, Инструкция по установке и программированию

Страница: 14 / 17

Page 14 of 17
Finish the gasoline configuration pressing one of following keys:
NEXT - LPG mode configuration
OK - save gasoline mode settings
SKIP - skip settings
CONFIGURATION – LPG
NOTE: LPG MODE CONFIGURATION SHOULD BE MADE AFTER PRELIMINARY PRESSURE REGULATOR
ADJUSTMENT! (SEE QUICK START P. 12)
LPG mode configuration may be activated with LPG or NEXT - if gasoline configuration has been
performed previously.
According to dialog window commands proceed as follows:

set AUTO working mode (control panel key or mouse)

increase rpm to ca. 2000 to switch over to LPG

leave idle rpm - actuator position will be adjusted

increase to 3000 rpm - actuator position will be adjusted

Finish the configuration with:
OK - save LPG mode settings
SKIP - skip settings
Other controller settings as e.g. sensor simulation, LPG mode on level etc. may be adjusted with menu
PARAMETERS .
QUICK START, FIRST PRESSURE REGULATOR ADJUSTMENT
First pressure regulator adjustment must be done before use of CONFIGURATION -LPG function.
Adjustment should be done using menu PARAMETERS .

start the engine in gasoline mode and wait for proper lambda sensor operation

set the controller for GASOLINE mode.

Check lambda sensor operation for idle and 3000 rpm (sensor indications should be between
upper and lower voltage value).

Set the controller for AUTO

Increase rpm to ca. 2000 to switch over to LPG

Watching lambda sensor graph at the oscilloscope adjust LPG output (with an adjustment screw
located on the pressure regulator) so that the actuator works in the range 50 - 100 steps (idle
engine rpm)

Check sensor balancing at 3000 rpm

If the sensor shows long return time to balancing during rpm change check pressure regulator
membrane tension and adjust it with a screw, if necessary.
NOTE: if during pressure regulator adjustment it is impossible to obtain sensor
balance at high rpm and the mixture is weak, it means that the system pressure
regulator - mixer does not work properly, thus before adjustment of electronics some
mechanical components must be adjusted. If the pressure regulator has been
adjusted and works properly, proceed with LPG CONFIGURATION .