autogaz AC STAG-100, Инструкция по установке и программированию

Страница: 10 / 17

Page 10 of 17
STAG-50/100/150 ADJUSTMENT PARAMETERS
IGNITION COIL - according to the connection of rpm pulse and ignition type it is indispensable to
choose such type of coil to obtain the same rpm indication at the tachometer and
software window. In certain vehicles it is indispensable to use an ignition pulse adder.
COIL SIGNAL – change of the rpm detection voltage threshold. Set suitable detection level
depending on rpm pulses voltage value.
TPS - after connection of a throttle opening sensor choose its type and voltage range.
TPS THRESHOLD – voltage level, which causes switching over from idle operation to operation
with load
ADJUSTMENT FROM TPS - adjustment from TPS on / off
TPS HISTERESIS - removal of voltage noise from the TPS sensor
ENRICHMENT - number of actuator steps proportional to accelerator's pressing
WEAKENING - number of actuator steps proportional to accelerator's loosing
ACTUATOR SPEED - actuator speed during enrichment / weakening
OPEN - additional opening of actuator after reaching of TPS level
TPS LEVEL - TPS voltage level causing mixture enrichment – additional opening of the actuator
ACTUATOR AT THE POSITION - number of actuator steps during additional opening
ACTUATOR SPEED - actuator speed during opening
CUT OFF - additional closing of actuator during accelerator's loosing and reaching TPS level
downward. This function works if rpm falls to the set level.
RPM LEVEL - rpm level activating CUT OFF function
ACTUATOR AT THE POSITION - number of actuator's steps during CUT OFF execution
ACTUATOR SPEED - actuator speed during CUT OFF
LAMBDA SENSOR TYPE - lambda sensor operation range
LAMBDA SENSOR - lambda sensor type:
STANDARD – zirconium
RESISTIVE (-) – load from the frame
RESISTIVE (+) – load from the positive pole (+)