AutoGate VPG2490, Руководство по введению

Страница: 7 / 16

7
The GENESIS board is one of the most advanced boards on the market to meet all the requirements for en-
trapment for UL-325. Your gate will not operate without wiring in the necessary “reversing protec on”
equipment.
The board has been designed to meet just about any accessory device and applica on you can think of.
Please review the next few pages for details on each board INPUT, OUTPUT, POWER and FUSING details.

Standard INPUTS for OPEN, CLOSE, STOP, Loops, Access Controls, Pushbuttons, etc.

6 “MONITORED” 10K entrapment device INPUTS for OPEN and CLOSE obstruction

Dedicated 1 BEAM and 1 EDGE “OPEN” obstruction

Dedicated 1 BEAM and 1 EDGE “CLOSE” obstruction

Two additional programmable for either OPEN or CLOSE obstruction

Additional Programmable Relays

Additional Programmable INPUTS

Additional Programmable OUTPUTS

24VDC Fused Accessory Power
12VDC Fused Accessory Power
SPECIAL NOTE: The GENESIS board can be retro fi t into older operators. If a Genesis board is to be used in non-
monitored entrapment device gate system, the required OPEN & CLOSE monitored inputs can be deac vated.
This will require a special passcode to allow the servicing dealer 24-hour access to programming that can bypass
the UL Rev. 6 code. To get the pass code, a phone call to AutoGate with the gate serial number or AG # and the 8
-character code displayed on the access screen. The AutoGate representa ve will read back a 5-character code
that will need to be entered on the display. Again, this will allow 24-hour access to this special programming
func on. A er that, if there would ever be a reason to access the special programming func ons, a new
passcode would be needed.
See the following pages for definitions of each terminal on the GENESIS control board.
Genesis Controller (cont.)
P4 & P5
MONITORED DEVICE CONNECTIONS POINTS
GENESIS INPUT & OUTPUT DETAILS