AUTOCAR Xspotter 2014, Руководство оператора

Страница: 29 / 118

Lowering the Cab
Lift the safety lock rod and pull it outward to
clear the guide pin (Figure 17) located on the
inside of the lock assembly bracket. It may be
necessary to raise the cab slightly using the
pump to relieve the tension on the safety latch.
Figure 17
Align the slot in the rod with the guide pin and
push the safety lock bar over the guide pin
(Figure 18).
Figure 18
Pull up on the Flow Control Knob (located on
top of the Tilt Pump) until the locating pin can
spin freely. Rotate the knob 90 degrees
counter-clockwise and release, at which point
the Locating Pin will re-seat in the original, or
down position (Figure 19).
Figure 19
To lower the cab, push and maintain pressure
on the tilt switch until the cab is in the fully
lowered position. The weight of the cab will
trigger the hydraulic latches to lock. This will be
evident when the pins in the hydraulic latches
retract into the latch body (Figure 20).
Figure 20
AWE 00054 Rev. 002 17
autocartruck.com
ACTT Xspotter Operator Manual