6
7
PAPER REPLACEMENT
1. Open cover by placing hands on both sides of the
cover, move the rubber boot to the side, and flip up on
the finger tabs.
2. Drop in thermal paper roll (as shown). Pull paper out
about 3" past the cover lid and hold.
3. Close the lid by pushing on it until you hear a snap.
Tear off excess paper. Paper is loaded and ready to
use.
Store / Mfg.
Part Number
Office Depot
209-653-271
Office Max
20121146
Quill
856607
Seiko
SS058-025A
Staples
531236
The “Printer Ready” LED will turn from green to amber
when paper needs replacement.
Replacement Paper: Standard 2-1/4” wide by 80’ long thermal paper
available at most office supply stores.
PRINTER OPERATION
1. After performing a test using your tester. Turn on the PR-20 printer
by pressing the “Power” button.
2. The printer is ready to use if both the “Power” and the “Printer
Ready” LED’s are green. If the “Power” LED is amber, recharge
the battery. If the “Printer Ready” LED is amber, replace the paper
roll.
3. Press the “Print” button on the tester. The test number and results
indicated on the tester LCD will print out on the PR-20 printer.
4. To feed the paper manually, press the “Line Feed” button to start
feeding the paper (The “Printer Ready” LED will flash green and
amber during the line feed). Pressing the “Line Feed” button again
will stop the line feed. The printer will automatically stop the line
feed after 10 seconds.
5. Turning the tester off will automatically turn the printer off. The
printer can also be turned off by pressing the “Power” button. The
printer will also automatically turn off after 4 minutes with no
operation.
Note
: A printer self test can be performed by simultaneously
pressing and releasing both the “Power” and the “Line Feed”
buttons at the same time.
