10
3
CONGRATULATIONS!
You have purchased Auto Meter’s Bolt Printing solution
designed to be installed over the top of your SB-300,
RC-300, BVA-300, and BVA-350 hand held testers. Pressing the “Print”
button on your tester sends the print job to the printer using a wireless
IR signal. The printer reads this signal and prints out the test results on
thermal paper. The printer comes with a rechargeable lithium-ion battery
that lasts for thousands of print lines before requiring a recharge. The
paper replacement utilizes an easy paper roll drop in design.
Auto Meter Model Number
PR-20
Print Mode
Thermal Sensitive Dot Matrix
Print Speed
30-62 mm/s
Print Resolution
8 dots/mm, 384 dots/line
Print Width
48 mm
Character Size
5-7 dots
Paper Roll Size
58 mm Wide X 25 m Long / 2.25" Wide X 80' Long (Max.
Roll Diameter: 2.0")
No Paper Detection
Yes
Paper Replacement
Easy Drop In
Power
7.4 V 1400mAh Li-ion (Canon BP-511 or Equivalent)
Low Battery Indicator
Yes
Battery Charge Time
2 Hours Approximate
Battery Charger
Included
Power Save Mode
Auto Turn Off After 4 Minutes Without Operation
Operating Temperature &
Humidity
0 to 120 F, 10 to 90% RH
Storage Temperature &
Humidity
-4 to 140 F, 10 to 90% RH
LIMITED WARRANTY
12 MONTHS FROM DATE OF PURCHASE
The manufacturer warrants to the consumer that this product will
be free from defects in material or workmanship for a period of
twelve (12) months from the date of original purchase.
Products that fail within this 12 month warranty period will be
repaired or replaced at the manufacturer's option to the consumer,
when determined by the manufacturer that the product failed due
to defects in material or workmanship. This warranty is limited
to the repair or replacement of parts and the necessary labor
by the manufacturer to effect the repair or replacement of the
product. In no event shall the manufacturer be responsible for
special, incidental or consequential damages or costs incurred
due to the failure of this product.
Improper use, accident, water damage, abuse, unauthorized
repairs or alterations voids this warranty. The manufacturer
disclaims any liability or consequential damages due to breach of
any written or implied warranty on its test equipment.
WARRANTY AND SERVICE INFORMATION
Warranty claims to the manufacturer's service department must
be transportation prepaid and accompanied with dated proof of
purchase. This warranty applies only to the original purchaser
and is non-transferable. Shipper damage incurred during
return shipments is not covered under this warranty. It is the
responsibility of the shipper (the customer returning the Test
Equipment) to package the tester properly to prevent any damage
during return shipment. Repair costs for such damages will be
charged back to shipper (customer returning the Test Equipment).
Protect the product by shipping in original carton or add plenty
of over-pack cushioning such as crumpled up newspaper.
