AUTIC APPC-1029T, Инструкция по установке и эксплуатации

Страница: 36 / 62

Autic System Marine PC Rev. 1.1 Page 36
ELECTRICAL INSTALLATION
The Monitor is certified for the connection to grounded power supply according to
EN60950. There are two power connectors to be able to use of two individual power
sources to obtain redundancy. 1 power connector can be used for single input.
Operation Voltage is from 9 to 32 VDC. Be aware of the current consumption for wire
dimension when using low supply voltage. Total power consumption can be up to 80
watt.
The power input has polarity protection if + and – should be interchanged during
installation.

Data cables connected to the unit should to be of the shield type.

We recommend that the shield is connected to ground on both sides.

We recommend using min. 4 mm² grounding wire.

Isolate PCB ground (0 V) from chassis ground (earth).

Signal ground (0 V) is isolated from chassis ground.
VERIFICATION
Please observe the following during installation and startup.
1) Be accurate when mounting the gasket tape between the front bezel and the panel.
2) Cover the ventilation holes with a piece of paper to prevent metal shavings from entering the unit.
Remove again after installation to ensure good ventilation.
3) Ground the unit according to installation instruction.
4) Make sure the polarity is correct for power connection before connecting to power outlet.
5) Keep signal cable and high voltage cable separated.
9-32VDC
Power
9-32VDC
Power
Ground