AUTEC Modular series, Руководство пользователя

Страница: 24 / 36

5 Operati
n
g mode of “Master/
Master”
- 20 - LIMM&SA0-00.fm
A transmitting unit that has engaged a receiving unit keeps control on it even after the
STOP pushbutton has been activated or after the transmitting unit has been switched
off.
A receiving unit gets back to its free status:
- if it is disconnected from its power source
- if it is released by the transmitting unit that had engaged it; release takes place
when the “Take/Release” command is activated.
5.2 Power on and start up
Follow this procedure to switch on and start up the transmitting units:
1.To switch on a transmitting unit, insert the starting keyswitch and turn it to “I” position.
2.To start the radio remote control functions, press the START pushbutton without releasing it
for 3-4 seconds. In order to engage a receiving unit, follow the procedure in paragraph 5.1.
After start up, the green signalling LED in the transmitting unit always lights up.
In order to engage the receiving unit, follow the procedure in paragraph 5.1.
In order to activate commands, follow instructions given in paragraph 6.1.
Signal type
LAMP (OR HORN)
connected to the terminal
ENA-M
LAMP (OR HORN)
connected to the terminal
ENA-S
OFF
the receiving unit URX-1 or URX-2 is
free from the transmitting unit UTX-M the receiving unit URX-1 or URX-2 is
free from the transmitting unit UTX-S
ON blinking
fast (3 sec.)
the receiving unit URX-1 or URX-2 waits
to be engaged by the transmitting unit
UTX-M (during start up) the receiving unit URX-1 or URX-2 waits
to be engaged by the transmitting unit
UTX-S (during start up)
steady ON
the receiving unit URX-1 or URX-2 is
used by the transmitting unit UTX-M the receiving unit URX-1 or URX-2 is
used by the transmitting unit UTX-S
ON
blinking slowly
the receiving unit URX-1 or URX-2 is
engaged by the transmitting unit UTX-M the receiving unit URX-1 or URX-2 is
engaged by the transmitting unit UTX-S