AUTEC Modular series, Руководство пользователя

Страница: 13 / 36

2
Transm
itting un
its
- 9 - LIMM&SA0-00.fm
2.3 Warnings for the use of the transmitting units
FAILURE TO COMPLY WITH THE FOLLOWING WARNINGS MAR RESULT IN SERI-
OUS INJURY OR DEATH TO PERSONNEL AND DAMAGE TO EQUIPMENT.
The user must always respect the following warnings:
Autec, or its distributors, cannot be held responsible if the radio remote control
is installed on applications other than those permitted and if used in irregular
working conditions.
The operator should always ensure that both units are complete and that the
gaskets, bellows and hoods of the actuators (joysticks, selectors, pushbuttons)
are whole. If they are not, the radio remote control must not be used before be-
ing repaired.
Visually follow all movements of all remote controlled machines and of all corre-
spondent loads; the user must therefore be in a position that offers the best vis-
ibility condition of the whole area.
Before using the radio remote control always make sure that the STOP pushbut-
ton can be pressed and released: if it does not work, do not use the radio remote
control.
First switch on and start the transmitting unit, and then check that the STOP
pushbutton works properly: if the machine movements are not stopped when it
is activated, do not use the radio remote control.
Switch off the transmitting unit when work is interrupted. Avoid leaving the load
suspended in the air (even when changing the battery).
Never leave the transmitting unit unguarded when the starting keyswitch is in-
serted.
Switch on or use the transmitting unit only when starting work: improper use
could be hazardous.
Never switch on or use the transmitting unit in closed spaces, with the machine
not in sight, or outside the typical working range.
When operating in tandem mode, always stay within the working range of both
receiving units, in order to facilitate radio link with each of them and to be sure
to control both receiving units.
Pay attention to the entire work area. Immediately press the STOP pushbutton
in case of hazard.
If the two machines do not have an alignment control system (see
paragraph 3.5), the user must be properly trained in order to operate correctly if
loss of alignment occurs.
In this case, immediately release the active command and/or activate the STOP
command.
Pay attention not to let elements such as concrete, sand, lime, etc. deposit on the
transmitting unit because they can compromise transmitting unit use and safety.
In case of malfunctions and/or damaged and/or faulty parts, put the radio re-
mote control out of use until the problem has been completely eliminated.
2.4 Warnings for the maintenance of the transmitting units
Ensure that the battery has been removed from the transmitting unit before car-
rying out any maintenance work.
Any failures should be repaired by authorised Autec personnel using original Au-
tec spare parts only.
In order to work with a unit that is always efficient and safe, it is necessary to carry out correctly
maintenance work (see chapter 7).