USER MANUAL
Scissor
ASLP-3005
ASLP-3005/IG
ISSUED 04-02-2004
AUTEC Hefbruggen bv
Industrieterrein Ijsselveld, Vlasakker 11, 3417 XT MONTFOORT, The Netherlands
Tel:+31 348 477000 Fax:+31 348 475104 E-mail: [email protected]
INDEX OF CONTENTS
PAG
1 Introduction
02
2 How to use this manual
02
3 Description of the lift
02
4 Technical specifications
03
5 Safety
03
6 Controls and operation
05
7 Maintenance
06
8 Troubleshooting
07
9 Conformity declaration
08
1. INTRODUCTION
CAUTION
This Manual is intended for factory
personnel who are going to operate
the lift; read the Manual before you
use the platform in any way or
perform any actions on it. This
Manual contains important
information about the following
points :
n
THE PERSONAL SAFETY OF THE
OPERATOR
n
PREVENT DAMAGE TO THE LIFTS
n
PREVENT DAMAGE TO THE
VEHICLE
2. HOW TO USE THIS MANUAL
The Manual forms part of the lift and
must be available for reference in the
immediate vicinity of the lift at all times.
The operator of the lift must be able to
refer to the Manual quickly and at any
given moment.
IT IS STRONGLY RECOMMENDED
THAT YOU SHOULD FIRST
CAREFULLY READ THE SAFETY
INSTRUCTIONS.
The manufacturer hereby refuses to
accept any responsibility for injury to
persons or damage to equipment or
property if it appears that incorrect
handling of the lift has taken place. This
instructions manual only describes the
operating- and safety aspects which
persons who are installing the machine
need to know. In order to understand
the terminology used in this manual, it is
necessary that the person performing
the installation work should have
specific experience in industrial work,
service, maintenance and repair
activities, and must also possess the
ability to explain the drawings and the
descriptions contained in this manual to
other people. At the same time he must
also be aware of the general and
specific safety regulations which apply
in the country where the lift is being
installed. The word “operator”, which
has been used throughout this manual,
refers to a person who is authorised to
use the platform. The minimum legal
age for using the lift is 18 years.
3. DESCRIPTION OF THE LIFT
(see Fig. 1)
The electro hydraulic lift model ASLP-
3005, is anchored to the ground, and is
designed and manufactured for lifting
passenger cars and delivery vanes and
to hold them in a certain lifted position.
The main components of the lift are :
n
Welded floor frame
n
Movable parts (supports and arms)
n
Lifting components
n
Control cabinet
n
Safety arrangements.
Fig. 1
See
Fig. 2
for the following terms :
1.
Operating side :
the area in which
the operator does his work, and
from where he can access the
control cabinet.
2.
Rear :
The side where the support
extension pieces are mounted.
3.
Front :
The side where the cylinder
rod is mounted on the frame.
4.
Sliding direction
: Direction in
which the vehicle will come sliding
in, with the motor-side of the vehicle
in the front.
Fig. 2
CONTROL CABINET (Fig. 3)
The electrical control cabinet consists of
the following :
1. Safety switch for completing the last
400 mm of the lowering motion
2. Voltage monitoring lamp
3. Signal lamp/horn
4. Emergency stop button
5. Downward motion button
6. Lifting motion button
7. Main switch
Fig. 3
There is a hydraulic part in the control
cabinet which consists of an oil tank, a
hydraulic pump, an electrical motor,
solenoid valves and hydraulic hoses.
These include the following :
n
Limit switches
n
Electrical safety arrangements
n
Overpressure valves
n
Hose rupture protection
en/TA-ASLP-3005-02
