Austroflamm 48x51x51 S3, Руководство по эксплуатации

Страница: 67 / 94

Operating manual Fireplace inserts S3 EN 11 | Installation
67
Selecting the program
Fig. 59: Unplugging the power supply
1) Remove power supply from the socket.
2) Remove the three screws and open the control unit
housing.
1
Fig. 60: Selecting the program
On the circuit board is a selector switch (1) that by default is
set to position “0”.
3) Select program by setting the arrow of the selector
switch to position 1, 2, 3 or 4 (see “Program Overview”
table.
4) Before closing the controls again, carry out a fresh cal-
ibration by plugging the power supply back in.
ð If you have selected the correct “sliding closing” or
“sliding opening” function, after the calibration the
controls must complete close the shutter.
ð Should you notice that you have chosen the wrong
program, you can change this in the service menu
of the app.
APP
The InsertControl function can be monitored using the app on iOS and Android Smartphones. To do
so, first load the “InsertControl” app from the iTunes Store or Google Play on to your Smartphone.
When it is connected to the circuit, InsertControl creates a WLAN with the name
“ABR_xxxxxxx” (xxxxxxx = serial number of the controls). You must connect your Smartphone to this
network (password: 12345678). After the app is started, the connection is automatically established.
If desired you can then connect the app to another WLAN (in the app’s settings menu). Please note
that a new calibration run for the controls will then be started.