8
User Guide
IP SETUP
Introduction
The IP function allows the DXE-CAT-RX3C and DXE-CAT-RX3C-A to be controlled via LAN. In
addition, the units can be set up with built in setup pages and even serve up web pages to
remote devices on the network for control.
Default IP
The default IP out of the box is 192.168.1.10 static. Make certain to change the IP on the unit at
a time or you will get collisions on the network. Each device must have a unique IP address.
DHCP can be used but it is recommended to issue IP address based on the MAC address. This
assures the DHCP does not reassign the IP address at a later time causing issues. Keep in
mind the processor is on the TX unit so only the TX needs to be connected when you are doing
the initial setup although having the RX will not affect the process and may be necessary only if
the LAN is connected at the RX side.
To access the settings via web browser use the units IP address/setup (ex. 192.168.1.10/setup)
The default user name is admin and the default password is admin.
In the event you lose your settings press and hold the setup button on the DXE-CAT-RX3C /
RX3C-A for 3 seconds. This will restore the unit back to factory default.
Usage
Only serial port 1 will be used to communicate to the RX3 at a baud rate of 115200. This baud
rate will be fixed but the ports for the RX3 must still be set up accordingly to the correct baud
rate to match the device they are connected to.
The !30PTL,x<cr> command must be sent first to pick which port (1 = HDBaseT or 2 = Local
RS-232) before sending a serial command out a port.
