Aurora Archer IS1200, Инструкция по установке и эксплуатации

Страница: 38 / 63

37
A.
With main electrical power to the fireplace turned off, install three AAA 1.5V Batteries i e remote. nto th
Set up remote per instructions on pages 34-40. After the remote is set up, ensure that the remote is turned
on and active. The remote display must show “Auto”, Manual” or “Pilot.”
B.
Turn on main electrical power to the fireplace. See Figure 48. The red and green control board LED lights
will begin flashing alternately. Each light will flash four times. Then the fireplace will enter standby and
the green LED light will begin to slowly flash. Verify power is on by checking if there is power t o the con-
trol board. If the fireplace has power, the green LED light on the control board will flash slowly.
C. The Display panel board should be energized, and a “double dash symbol” (—) the power light will be
displayed. See figure 49. The remote receiver
automatically links to the remote transmitter signal. If the fireplace does not respond to the remote, when in
remote mode as indicated by the double dash symbol, turn the main power off (Figure 46) and make sure
the remote if on and active before turning main power back on.
D. Turn on the main gas supply.
START UP AND ADJUSTMENTS WITH REMOTE
CAUTION:
if the fireplace experiences an unexpected loss of power while the remote is operating in the ther-
mostatic mode the remote’s thermostatic function will need to be manually reset after the power is restored in
order for the fireplace to resume normal operation. Press the remotes power button to turn it off then ba ck on
to reset the thermostatic function.