AURATON T-1 RT, Руководство пользователя

Страница: 8 / 16

8
Pairing of the wireless AURATON RT controller with
the AURATON RT receiver
Deregistering the regulator from the RT receiver
After the receiver is connected to the network, the receiver must be switched on by
quickly pressing the power button ( ). If the device is switched on, the green power
supply diode becomes illuminated and a single sound signal is emitted. In order to switch
off the receiver, e.g. outside of the heating season, press the power button and hold it
for 3 seconds until a double sound signal is audible and the green power supply diode
is switched off and, consequently, the heating device is switched off.
In the event of an error during the pairing process, repeat steps 1 and 2. Should more
errors occur, deregister all devices by executing the RESET function of the RTH receiver
(see “RESET – Deregistering all devices paired with the RT receiver”) and attempt to pair
the device again.
NOTE: One receiver can have only one temperature regulator assigned.
NOTE: The AURATON T1 wireless temperature regulator sold with the AURATON RT
receiver is already paired. Devices sold separately require “pairing”.
1.
Pairing of the AURATON T-1 controller with the AURATON RT receiver is initiated by
pressing the right pairing button (green triangle – ) a single sound signal is emitted – on
the AURATON RT receiver and by holding it pressed for at least 3 s until the LED diode
starts blinking with green light (double sound signal) – then the button must be released.
The AURATON RT receiver waits for pairing for 120 seconds. After that time, it auto-
matically returns back to normal operation.
2. Press the pairing button ( ) placed on the rear side
of housing and hold it for about 2 seconds. When LED
diode ( ) will starts flashing red stop pressing the button.
3.
A properly completed pairing process is signalled by the
LED on the AURATON RT receiver no longer flashing
green and the receiver reverting back to normal
operation.
1. Deregistering the T-1 regulator from the RTH receiver is initiated by pressing the right
deregistering button (marked with a red triangle – ) on the RTH receiver and holding
it for at least 2 seconds, until the LED starts flashing red, and then releasing the button
The AURATON RTH receiver waits for deregistering for 120 seconds. After that time,
it automatically returns back to normal operation.
LED