Rev. 2/13
AM12MF18-1
7
fan guard to the fan motor head with four 3.9x16 screws
(fig 7)
.
9. Mount the fan blade to the fan motor shaft. Make sure the fan blade screw aligns with the flat on the
motor shaft and tighten the fan blade screw which has already assembled in the fan blade
(fig 8)
.
10. Align the front and rear guard and assemble together and secure with four 3.9x16 screws
(fig 9)
.
11. Remove the protective covering and connect the air tube and water tube to the connectors on the front
of fan pole assembly by pushing the tubes all the way into the corresponding connectors. (Note, small
diameter tube = Water and large diameter tube = Air)
(fig. 10)
.
IMPORTANT:
Read this owner’s manual before operating this product.
Place the misting fan on a level surface near an electrical outlet. Place the misting fan out of reach of
children. Do not insert anything into the fan guards. If moving the misting fan to a different location, turn it
OFF and unplug it from the socket.
Testing the GFCI
1. Put the plug into the grounded outlet, the indicator light on the GFCI lights up
(fig. 1)
.
2. Turn the motor on by flipping the switch to ON position ("I" "II" or "III"), press "TEST" button on the
GFCI, the light goes out and the unit stops working
(fig. 2)
.
3. Then press "RESET" button on the GFCI, the indicator light lights up and the unit powers on
immediately
(fig. 3)
.
•
To operate the misting mist fan, plug the power cord into a 120 VAC, 60Hz outlet.
CAUTION:
MISTING FAN AND/OR MISTING SYSTEM MAY START UP WHEN
THE UNIT IS INITIALLY PLUGGED INTO THE POWER OUTLET
.
Operating Instructions
