Rev. 2/13
AM12MF18-1
6
A Phillips head screwdriver is needed for assembly.
1. Ensure that the power cord is disconnected from the power outlet.
2. Insert power base pole through hole in the power base as illustrated, and fasten with the four 3.9x16
screws
(fig. 1)
.
3. Align fan motor head to the fan pole hole as illustrated, and fasten the fan motor head to the fan pole
with the one M5x16 screw
(fig. 2)
.
4. Align fan head & pole assembly to the power base assembly as illustrated, and press the fan head
assembly until the screw hole is aligned to the fan pole hole, fasten the fan pole assembly to the power
base assembly with one M5x16 screw
(fig. 3)
.
5. Connect fan pole wire connector to power base wire connector (be sure to push connectors fully
together until locked). Fasten the junction box cover to the fan pole assembly with the four 3.9x16
screws
(fig. 4)
.
6. Remove the protective covering and connect the air filter assembly and water filter assembly to the
connector on the power base assembly by pushing the tubes all the way into the corresponding
connectors
(fig. 5)
.
7. Install filter access door to the fan pole assembly
(fig 6)
.
8. Align the rear fan guard alignment hole to the alignment pin on the motor housing, and fasten the rear
General Assembly Instructions
