AUO AC UNISON, Руководство по установке

Страница: 30 / 44

AUO AC Unison
[AUO AC Unison Installation Guide] [Page 29 of 44] [February 2012 Rev. 1.0]
ABB, APC or Polyphaser can be designed to the practices in your area and installed in the home, more component level
solutions can be purchased from companies like Dehn, Cital or Delta Lightning Arrestors (e.g. Delta LA 300 Series surge
arrestors and CA 300 Series surge capacitors).
NOTE: Proper grounding of the AC Unison module system will ensure full warranty coverage. Although highly recommended,
the installation of auxiliary lightning protection systems / components is not specifically tied to the AC Unison module’s
warranty. The conductor used for lightning protection from the structure to the grounding electrode system must not be run
inside the same conduit that contains the EGC and AC circuit conductors.
FCC Compliance of AC Unison modules and Data Logger
The equipments have been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an output on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Safety Certification of Data Logger
ETL listed to UL60950-1 ITE and UL60950-22 for outdoor use.
The Data Logger is not a utility meter, disconnect device, or power distribution device.
Safety instructions for Data Logger
Installation and field service is to be performed only by qualified, trained personnel with the necessary skills and knowledge to
work on this type of electrical equipment. Field service is limited to the components contained in the lower compartment of the
Data Logger.
- Perform all electrical installations in accordance with any local codes, the National Electrical Code (NEC) ANSI/NFPA 70
for US installations, or the Canadian Electrical Code Part I, CSA C22.1 for Canada.
- Suitable for use indoors or outdoors (Type 3R enclosure). Operating ambient from -20°C to 50°C.
- Identification label and power rating for this device are located behind the front access cover.
- Before connecting power, the Data Logger must be securely mounted to an inside or outside wall following the instructions
in this document.
- For permanently connected equipment, a readily accessible disconnect device must be incorporated external to the
equipment.
- The Data Logger can be connected to a branch circuit with any standard size breaker rating up to 20A. The input
operating current is less than 0.1 amps.
- The Data Logger contains internal transient surge protection for connection to the load side of the service entrance AC
panel. For installations in areas at risk of surges generated by high voltage utilities, industry or by lightning, it is