AUMA GST 10.1, Руководство по эксплуатации и инструкция

Страница: 10 / 24

.
If the output drive type A is already mounted to the gearbox: Loosen
screws [3] and remove output drive type A [2].
.
Check if the flange of output drive type A matches the valve flange [4].
.
Apply a small quantity of grease to the valve stem [1].
.
Place output drive type A on the valve stem and turn until it is flush on the
valve flange.
.
Turn output drive type A until alignment of the fixing holes.
.
Screw in fastening screws [5], however do not completely tighten.
.
Fit gearbox on the valve stem so that the stem nut dogs engage into the
output socket.
The flanges are flush with each other if properly engaged.
.
Adjust gearbox until alignment of the fixing holes.
.
Fasten gearbox with screws [3].
.
Fasten screws [3] crosswise with a torque according to table 2.
.
Turn gearbox and actuator with handwheel in direction OPEN until valve
flange and output drive type A are firmly placed together.
.
Tighten fastening screws [5] between valve and output drive type A
crosswise applying a torque according to table 2.
Protection tube for rising valve stem
.
Seal thread of protection tube with hemp, Teflon tape, or thread sealing
material.
.
Screw protection tube (1) into thread (figure 6) and tighten it firmly.
.
Push down the sealing (2) to the housing.
.
Check whether cap (3) is available and without damage.
.
10
Spur gearboxes GST 10.1 – GST 40.1 Operation instructions
3
1
2
Figure 6: Protection tube for rising valve stem
Ouput
drive
A 07.2 A 10.2 A 14.2 A 16.2 A 25.2 A 30.2 A 35.2 A 40.2
Qty
1)
1.5 g 2 g 3 g 5 g 10 g 14 g 20 g 25 g
1) For grease with density
ρ
= 0.9 kg/dm³
Table 3: Grease quantities bearings output drive type A