Auerswald a/b-Audiobox, Руководство по эксплуатации

Страница: 28 / 40

Settings
28
a/b-Audiobox - Operation Guide - V03 10/2020
The a/b-Audiobox continues to be in programming mode. For ad -
ditional programming actions, begin with the 3rd step.
Assigning a/b Switching Modules to the Key on the Device
If a/b switching modules are assigned to the key on the device (programming
key), you address these a/b switching modules by pressing the key.
Note: If several a/b switching modules are to be addressed at once, you
must set the same switching frequencies on these a/b-switching modules.
Requirements:
– Connection has been made to the internal a/b port on a PBX
– An internal telephone number has been set up for the a/b-Audiobox on the
PBX
– Knowledge of the PIN (0000 in the factory settings)
– DTMF-enabled internal telephone or DTMF tone generator
– Programming mode has been initiated (by pressing and holding the pro
-
gramming key for five seconds)
1. Pick up the receiver of an internal telephone.
2. Dial the internal telephone number of the a/b-Audiobox.
This establishes the connection.
3. Dial
*
.
You will hear the confirmation tone (five sequential tones).
Note:
If you only hear a short sound instead of the confirmation tone (after
restarting programming mode), enter the PIN and then dial
*
again.
4.
After the confirmation tone ends, dial one of the following character strings.
310
: Assigns no a/b switching modules to the key (factory settings).
311
: Assigns a/b switching modules with switching frequency 1 to the key.
312
: Assigns a/b switching modules with switching frequency 2 to the key.
313
: Assigns a/b switching modules with switching frequency 3 to the key.
314
: Assigns a/b switching modules with switching frequency 4 to the key.
315
: Assigns a/b switching modules with switching frequency 5 to the key.