Auerswald a/b-Audiobox, Руководство по эксплуатации

Страница: 26 / 40

Settings
26
a/b-Audiobox - Operation Guide - V03 10/2020
Switching over a Switching Function Manually
You can use this programming to manually toggle the switch contacts on the
switching output while the a/b-Audiobox is in programming mode (Switching
during the announcement, see
page 34
).
Requirements:
– Connection has been made to the internal a/b port on a PBX
– An internal telephone number has been set up for the a/b-Audiobox on the
PBX
– Knowledge of the PIN (0000 in the factory settings)
– DTMF-enabled internal telephone or DTMF tone generator
– Programming mode has been initiated (by pressing and holding the pro
-
gramming key for five seconds)
1. Pick up the receiver of an internal telephone.
2. Dial the internal telephone number of the a/b-Audiobox.
This establishes the connection.
3. Dial
*
.
You will hear the confirmation tone (five sequential tones).
Note: If you only hear a short sound instead of the confirmation tone (after
restarting programming mode), enter the PIN and then dial
*
again.
4.
After the confirmation tone ends, dial the character string
63
.
You will hear the confirmation tone (five sequential tones).
The switch contacts remain switched on or off dependent on their
state.
The a/b-Audiobox continues to be in programming mode. For ad
-
ditional programming actions, begin with the 3rd step.
Assigning a/b Switching Modules to the Switching Function
If a/b switching modules are assigned to the switching function, you address
these a/b switching modules simultaneously with the switching output's switch -
ing function.