5
Signalling tone group GroupF programming procedure
Any one of the signalling tones from the table “Signalling tone description” may be freely
assigned to the settings Stage 0, Stage 1, Stage 2 and Stage 3 of the signalling tone group
GroupF, in order to compose exactly the 4 signalling tones in signalling tone group GroupF
that are required for a certain application.
Programming the signalling tone group GroupF
a.) First, turn the rotary switch S1 (Vol./Prog. Select 0..F) to one of the positions 8, 9, A or
B, in order to force the device into the “mute” setting when the mains supply is switched
on.
b.) Turn on the mains supply of the device. The device goes mute and LED H1 is switched
on.
c.) In order to change a particular signalling tone, use the rotary switch S1
(Vol./Prog. Select 0..F) to select the corresponding setting among the Stage 0, Stage 1,
Stage 2 or Stage 3 settings of signalling tone group GroupF. Do this by turning the
rotary switch S1 to position 8 (Stage 0), 9 (Stage 1), A (Stage 2) or B (Stage 3).
d.) Select the desired new signalling tone from the table “Signalling tone description”.
e.) If the selected signalling tone belongs to the tone interval Tone0 to ToneF, place the
jumper in jumper field X1 in position LS. Otherwise, place the jumper in position US.
Turn the rotary switch S2 (Group/Tone Select LS:0..F US: 10..1F) to the position
corresponding to the last character of the line name of the selected signalling tone. For
instance to position A for the selected signalling tone ToneA or to position 5 for the
selected signalling tone Tone15.
f.) Press push button S3 (Enter) to trigger the programming procedure. LED H1 will be
turned off during programming, and then on again after the programming is completed.
Repeat steps c.) to f.) for all the settings of those tones of signalling tone group GroupF
that you want to change.
g.) Turn off the mains supply of the device.
h.) Turn rotary switch S1 (Vol./Prog. Select 0..F) back to the preferred volume setting
between position 0 and 7, place the jumper in jumper field X1 in position LS, and turn
rotary switch S2 (Group/Tone Select LS:0..F US: 10..1F) to position F.
Pick up the loudspeaker part of the housing again, connect the loudspeaker cable with the
circuit board in the lower part and place the loudspeaker part on top of the lower part.
Connect the housing parts with each other using the 8 housing screws.
(Torque 3 Nm
±
0.3 Nm)
