Technical
Re-programming the control buttons (pairing).
All systems are pre-programmed in the factory.
When a new transmitter must be paired to the system check below protocol to perform
the “pairing”.
-
Take out the transmitter from the system.
-
Unplug the power for 20 seconds
-
Plug in power for 10 seconds
-
Unplug power for 2 seconds
-
Plug back in the power, the motor will rotate for a few seconds.
-
When the motor has stopped, press the small “prog” button on the back of the
PCB (see picture).
-
The motor will rotate left and right shortly
Audipack
Industriestraat 2
2751 GT
Moerkapelle
+31(0)79 593 1671
Programm button