TROUBLESHOOTING - Horn / Chirps:
My system does not chirp when Arming and Disarming.
I cannot turn my chirps on ( or off ).
The alarm will set, but will not sound when opening a door.
Open the driver's door, then press the LOCK button to arm
the system. Did the horn chirp 3 times ?
SYMPTOMS
YES
NO
Does the SE system make the horn
sound under any conditions, ( IE: full trigger, pre-
warn, or remote panic ?
YES
*Repair BROWN door
trigger wire from
alarm, or the defective
door pin switch, then
start over.
*Inspect and repair
GREEN with RED
STRIPE horn wire
from alarm harness.
YES
Defective module.
Replace module.
NO
QUESTION
Does the system operate properly now ?
*Turn the chirps ON according to the
procedure on page 9.
YES
Diagnosis
Completed.
NO
The procedure to turn
chirps on will not
work.
HELPFUL HINTS :
1) The arm and disarm chirps are turned on and off by using the L.E.D. / Valet switch in combination
with the ignition switch. The SE system does not use dip switches to turn the chirps on
and off.
2) When the chirps are turned off, the 3 chirp ( armed with a door open - "defective zone" ) and 4 chirp
( disarm after alarm trigger - "intrusion alert" ) signals will always remain on. There is no way to defeat
the 3 and 4 chirp signals.
BEGIN TROUBLESHOOTING
QUESTION
Turn the ignition key to ON, then push the L.E.D.
/ Valet switch to the ON ( IN ) position. Does the
dash L.E.D. turn On ?
YES
*Repeat procedure to
turn chirps on, but
this time quicker. You
have only 5 seconds
to complete this.
*Repair connection
on YELLOW ignition
wire on the alarm
harness.
NO
QUESTION
Does the SE system make the horn
sound under any conditions, ( IE: full trigger, pre-
warn, or remote panic ) now ?
Start again from the
beginning.
NO
Page 11
